Milnor 36026V7Z User Manual

Chapter 1. How to Use the MilTouch
™
Control
1.1.1.4. Data Transfer with the MilTouch Programmer Software—Use the procedures in
this section to transfer these types of data between a MilTouch machine and a personal computer
unning the MilTouch Programmer software: r
• machine configurations
• wash formulas.
1.1.1.4.1. How to Mount a USB Flash Drive to the Machine Controller—This procedure requires
USB flash drive. a
1. At the MilTouch machine, touch the Data Exchange button on the Home display (Figure 1) to
access the Data Transfer display (
Figure 7).
2. While the Information box is visible, attach a blank USB flash drive in the USB port on the
left side of the machine control box.
3. Touch the button in the Information box to clear the box.
4. If a green "+" is visible on the External Media button, then touch the button to mount the
USB flash drive. If a red "-" is visible on the button, continue with this procedure.
5. Touch the External Storage button to save the machine configuration on the flash drive.
6. Touch the Transfer Configuration button.
1.1.1.4.2. H ow to Save Machine Configuration Files—This procedure requires a USB flash drive.
1. Touch the Data Set Name button.
2. To change the name of the configuration file, touch the Rename Data button, replace the
original name, and touch the button in the Information box to confirm the change.
3. Touch the bottom green Transfer Direction button to copy the configuration to the flash
drive.
4. Touch the button to confirm the successful export.
5. Touch the External Media button to unmount the flash drive.
6. Store the flash drive in a safe place.
1.1.1.4.3. How to Transfer Machine Configuration Files to a MilTouch Machine—This
procedure requires a USB flash drive that contains one or more MilTouch configuration files. The
revious section describes how to save machine configuration files to a USB memory flash drive.p
1. Access the Data Transfer display.
2. Mount the flash drive according to
Section 1.1.1.4.1.
3. Touch the External Storage button to see a list of the available configuration files.
4. Touch the desired configuration file in the stored data area (
Figure 8).
5. Touch the top green Transfer Direction button to copy the configuration to the machine
controller.
6. Confirm the successful import, unmount the flash drive, and remove the flash drive from the
machine controller.
1.1.1.4.4. H ow to Save and Transfer Wash Formulas
1. This procedure requires a USB flash drive.
2. Access the Data Transfer display.
3. Mount the flash drive according to
Section 1.1.1.4.1.
4. Touch the Transfer Wash Formulas button.
PELLERIN MILNOR CORPORATION
17

Milnor 36026V7Z Specifications

General

Brand	Milnor
Model	36026V7Z
Category	Washer
Language	English