Chapter 4. Troubleshooting
4.1.19. Loading Aborted
This error appears only on machines equipped with an automatic loading elbow. An error
o m to stop.
4.1.20.
his er r appears only on machines e ith an automatic loading elbow. An error
stem to stop.
4.1.21.
use value for this field t t does not exist in the Mildata co puter.
4.1.22.
ipped with an automatic loading elbow.
4.1.23.
machines eq ipped with an automatic loading elbow. The controller
n not e sure that the elbow is up and
4.1.24.
e use entered a value for this field t does not exist in the Mildata computer.
4.1.25. nval Goods Code
e use entered a value for this field t t does not exist in the Mildata co puter.
4.1.26. Invalid Customer Code
e use ield t at does not exist in the Mildata co p
4.1.27. l
e use entered a value for this field t t n e M ata co p
4.1.28. an' ind Data
e formula r uested e machine was not fo nd on the Mildata
te
4.1.29.
r not occur on MilTouch X models. The microprocessor detect
e cumulator data was corrupt. All accumulators must be reset to zero.
— End of BICLUT03 —
ccurred that caused the loading syste
Discharge Aborted
T ro quipped w
occurred that caused the discharge sy
Invalid Formula
e
Th r entered a ha m
Load Eye Blocked
This error appears only on machines equ
Up Lock Not Made
This error appears only on u
ca b locked in a safe position.
Invalid Work Order
Th r tha
I
id
Th r ha m
Th r entered a value for this f h m uter.
I
nva id Employee Code
Th r ha does not exist i th ild m uter.
C
t F
Mildata machines only. Th eq by th u
compu r.
Accumulator was Reset
This e
mpl
ror does
d-formula ac
-E ed that the
co te
BICLUT01 (Published) Book specs- Dates: 20151112 / 20151112 / 20151112 Lang: ENG01 Applic: CLJ
4.2. Inputs and Outputs for the MilTouch
™
Controller
Use the information in this document to diagnose and communicate about the machine with a
qualified technician.
Notice 3 : The data in this document applies specifically to the Milnor MilTouch
™
input-
PELLERIN MILNOR CORPORATION
41
To Next Page
Loading...
Need help?
General
