[
2
]
The current settings will appear.
Move the cursor to the "Auto-Off" or "Stop in --- min" with the
F1
or
F2
button.
Button operation
[
1
]
Bring up the Timer setting screen. (Refer to page 22.)
Select "Auto-Off", and
press the button.
Auto-OFF timer
The Auto-Off timer will not work in the following cases:
when Auto-Off timer is disabled, during an error, during check (in the service
menu), during test run, during remote controller diagnosis, when the clock is
not set, during Function setting, when the system is centrally controlled (when
On/Off operation from local controller is prohibited).
[
3
]
Change the setting with the
F3
or
F4
button.
Administrator passwaord setting. (Refer to page 51)
• Auto-Off : No (disable) / Yes (enable)
• Stop in --- min : Timer setting
(The settable range is 30 to 240 minutes in 10-minute incre-
ments.)