FUEL SYSTEM
8-20
3.4 Installing governor assembly
(1)
Install the governor assembly onto the pump housing.
(2) Connect the tie-rod and the tie-rod spring to the pumps.
(3) Install the tie-rod cover.
Removing governor assembly
3.5 Installing fuel injection nozzle
(1)
Clean the nozzle holder hole of cylinder head.
(2) Install the gasket to the nozzle tip and tighten the fuel
injection nozzle.
Installing fuel injection nozzle
3.6 Installing fuel pipes
(1)
Install the fuel leak-off pipe onto the fuel injection
nozzles.
(2) Install the fuel injection pipes, and hold them in place
with clamps.
(3) Tighten the fuel leak-off and fuel injection pipe nuts to
the specified torques.
Installing fuel pipe
49.0 to 58.8 N·m
{5.0 to 6.0 kgf·m}
[36.2 to 43.4 lbf·ft]
Replace
Tightening torque for
fuel injection pipe nuts
24.5 to 34.3 N·m
{2.5 to 3.5 kgf·m}
[18.1 to 25.3 lbf·ft]
Tightening torque for
fuel leak-off pipe nuts
20.6 to 24.5 N·m
{2.1 to 2.5 kgf·m}
[15.2 to 18.1 lbf·ft]
To Next Page
Loading...
Need help?
General
