SERVICE DATA
2-5
1.3 Fuel system
1.4 Lubrication system
1.5 Cooling system
1.6 Inlet and Exhaust system
Table 2-3 Maintenance service data table - Fuel system Unit: mm [in.]
Inspection point Nominal Standard Limit Remark
Fuel injection nozzle
Valve opening pres-
sure
13.73 MPa
{140 kgf/cm²}
[1991 psi]
14.22 to 15.00 MPa
{145 to 153 kgf/cm²}
[2062 to 2176 psi]
Adjust with washers
Standard is new parts value.
Table 2-4 Maintenance service data table - Lubrication system Unit: mm [in.]
Inspection point Nominal Standard Limit Remark
Relief valve opening pressure
0.3 to 0.4 MPa
{3 to 4 kgf/cm²}
[43 to 57 psi]
Replace
Oil pressure at which oil pressure switch
illuminates
0.04 to 0.06 MPa
{0.4 to 0.6 kgf/cm²}
[5.6 to 8.4 psi]
Replace
Table 2-5 Maintenance service data table - Cooling system Unit: mm [in.]
Inspection point Nominal Standard Limit Remark
Thermostat
Temperature at which valve
starts opening
82 ± 1.5°C
[179.6 ± 2.7°F]
Replace
Temperature at which valve
lift becomes 8 [0.32] or more
95°C
[203°F]
Thermoswitch
At 111 ± 3.5°C
[231.8 ± 6.3°F]
30 mΩ
(in oil of 105°C [221°F])
Replace
Deflection amount of belt
(when it is pushed between crankshaft pulley and
alternator pulley with a force of approx.
98 N {10 kgf} [22.03 lbf])
10 to 12
[0.39 to 0.47]
Table 2-6 Maintenance service data table - Inlet and Exhaust system Unit: mm [in.]
Inspection point Nominal Standard Limit Remark
Distortion on mounting surfaces of intake cover
and exhaust manifold
0.15
[0.0059] or less
Repair by grinding
or replace
To Next Page
Loading...
Need help?
General
