REASSEMBLY OF BASIC ENGINE
7-10
2.5 Installing camshaft
&$87,21
Be careful not to damage camshaft journals, cams and
camshaft holes during insertion.
(1) Apply engine oil to the camshaft journals and cams.
(2) Slowly insert the camshaft assembly.
(3) Tighten the thrust plate bolt to the specified torque.
(4) Make sure that the camshaft rotates lightly. Move the
camshaft gear back and forth, and make sure there is
end play.
Installing camshaft
Installing thrust plate
2.6 Installing idler gear
(1)
Apply engine oil to the idler gear shaft.
(2) With aligning the timing mark, install the idler gear.
(3) Check the backlash between the gears.
Align the timing marks.
2.7 Installing timing gear case
(1)
Apply sealant to the gasket to prevent it from displacing
and install the gasket on the front plate.
(2) Apply engine oil to the oil seal lip.
(3) Install the timing gear case and tighten the bolts.
Installing timing gear case
Apply engine oil
9.8 to 11.8 N·m
{1.0 to 1.2 kgf·m}
[7.2 to 8.7 lbf·ft]






To Next Page
Loading...
Need help?
General
