ELECTRICAL SYSTEM
12-8
2. Disassembling, inspecting and reassembling electrical system
2.1 Inspection before disassembling starter
2.1.1 No load test
&$87,21
Use as thick a wire as possible and firmly tighten each
terminal.
When detecting the rotation at the tip of the pinion, be
careful, as the pinion pops out during operation.
(1) Connect the starter to the circuit as shown in the
illustration.
(2) In normal condition, the pinion pops out when the
switch is turned ON, and the starter rotates at or more
the specified rotation speed.
If the terminal voltage, current or rotation speed does
not meet the standard, disassemble, inspect and repair
the starter.
Test at no load
A
V
B
S
M
Ammeter
Battery
12V
Voltmeter
Switch
Starter
Item Standard
Starter model name M001T68281 M008T70471A M008T81071A
Nominal output (V-kW) 12 - 1.7 12 - 2.0 24 - 3.2
No-load characteris-
tics
Terminal voltage (V) 11 11 23
Current (A) 110 or less 130 or less 80 or less
Rotation speed ( min
-1
)
2400 or more 3600 or more 3000 or more
To Next Page
Loading...
Need help?
General
