7.5.1
Turning Scan On or Off
Procedure:
Press the preprogrammed Scan button to toggle SCAN ON or SCAN OFF to initiate or stop scan.
If the scan is enabled, the display shows SCAN ON and the scan status icon.
If the scan is disabled, the display shows SCAN OFF.
7.5.2
Making a Dynamic Priority Change (Conventional Scan Only)
When and where to use:
While the radio is scanning, the dynamic priority change feature allows you to temporarily change any
channel in a scan list (except for the Priority-One channel) to the Priority-Two channel.
This change remains in effect until scan is turned off. Scan then reverts to the default setting.
Procedure:
• Making a Dynamic Priority Change using the preprogrammed Dynamic Priority button:
a. When the radio locks onto the channel designated as the new Priority-Two channel, press
the preprogrammed Dynamic Priority button.
The radio continues scanning the remaining channels in the list.
7.5.3
Deleting a Nuisance Channel
When and where to use:
If a channel continually generates unwanted calls or noise (termed “nuisance” channel), you can
temporarily remove the unwanted channel from the scan list.
This capability does not apply to priority channels or the designated transmit channel.
NOTE: Deleting a nuisance channel is only possible through the preprogrammed Nuisance
Channel Delete button.
Procedure:
When the radio is locked onto the channel to be deleted, press the preprogrammed Nuisance
Delete button.
The radio continues scanning the remaining channels in the list.
7.5.4
Restoring a Nuisance Channel
Procedure:
To restore the deleted nuisance channel, perform one of the following actions:
• Stop and restart a scan.
• Mode change to another channel and back to the original channel.
• Turn off the radio and then turn it on again.
MN002667A01-AV
Chapter 7 : Advanced Features
45
To Next Page
Loading...
Need help?
General
