• Optional Data Radio (Trunking)
• Accountability Server (Trunking)
• DVRS (Optional)
If you have a critical situation, you can press the Emergency button, which activates an alarm on the
Incident Management Software at the command terminal.
The command terminal receives the following status updates from your radio:
• Turning the radio on and off
• Automatic response to Polling
• Response to Evacuation commands
• Pressing the PTT button to make voice transmission
• Sending an Emergency Alarm and Call
• Entering or Exiting a Trunking Talkgroup
7.10.1
Entering Fireground Zone Channel (Conventional)
Procedure:
1 Upon powering up, one of the following scenarios occurs:
• If the Fireground Zone Channel is set as default, you hear the gurgle tone and the radio
displays the home screen. You are in Fireground zone channel.
• If the Fireground Zone Channel is set as default, but you hear a short, low-pitched tone,
the display shows REG FAIL to indicate that the command terminal does not respond to
Fireground Zone Channel. Get a qualified technician for assistance.
• If your home channel is not Fireground Zone Channel, toggle or change the radio zone
channel to Fireground Zone Channel.
If you are entering Fireground Trunking Talkgroup, upon powering up, ensure that the
Fireground Trunking Talkgroup is selected. The subscriber unit automatically appears on the
Incident Commander's terminal.
2 Listen for a transmission. Adjust the Volume Control Knob if necessary.
3 Perform one of the following actions:
• Press and hold the preprogrammed Volume Set button to hear the volume set tone. Adjust
the Volume Control Knob if necessary. Release the Volume Set button.
• At the desired Fireground zone and channel, press the preprogrammed Monitor button and
listen for activity. Adjust the Volume Control Knob if necessary.
• If your radio is working in Fireground Zone Channel, proceed to next step.
4 Press and hold the PTT button to transmit. The LED lights up solid red while transmitting. Talk
into the microphone clearly if needed.
5 Release the PTT button to receive.
You hear a Transmit End Tone.
7.10.2
Responding to Evacuation Indicator
When and where to use: The Incident Commander can trigger one of sixteen Tactical Alerts from
the Command Terminal. These alerts can target individuals or groups of users within the Fireground
MN002667A01-AV
Chapter 7 : Advanced Features
54
To Next Page
Loading...
Need help?
General
