Scenario Outcome
If you change to a channel or mode with Emer-
gency capability while in Emergency operation,
the Emergency Alarm and/or Emergency Call
continues on the new channel or mode.
If the radio is out-of-range of the system or the
emergency alarm is not acknowledged,
your radio shows the following indications:
• A tone sounds.
• The display shows No acknowledge.
7.9.2
Emergency Keep-Alive
This feature prevents your radio from turning off when in Emergency mode. If this feature is enabled,
you are required to exit Emergency mode before turning off your radio.
7.9.3
Exiting Emergency Operation
If an Emergency operation is triggered on your radio, the dispatch console or radios configured as
Supervisor can exit the Emergency operation.
Procedure:
To exit Emergency operation, press and hold the programmed Emergency button.
7.9.4
Exiting Emergency as Supervisor (Trunking Only)
Radios configured as Supervisor are able to cancel emergency mode of other radios. The dispatch
console must be preprogrammed to use this feature. For more information, contact your system
administrator.
Procedure:
1 Perform one of the following actions:
If… Then…
If the emergency mode is initi-
ated by other radios,
press and hold the Side Button 1 and press the Emer-
gency button.
If the emergency mode is initi-
ated by the Supervisor,
Perform one of the following actions:
• Press and hold the Emergency button.
• Press and hold the Side Button 1, and press the
Emergency button.
• Wait for console to clear emergency.
NOTE: The combinations of the following buttons are supported in your radio:
• Radio Side Button 1 and Top (Orange) button.
• Radio Side Button 1 and accessory Orange button.
• Accessory 1-Dot Button and radio Top (Orange) button.
• Accessory 1-Dot Button and accessory Orange button.
MN002667A01-AV
Chapter 7 : Advanced Features
49
To Next Page
Loading...
Need help?
General
