Fall Alert Enhanced
Your radio also supports Fall Alert Enhanced where an alert tone is played for a programmed period.
This tone is louder than the programmed minimum level or the current level of the speaker. This tone
acts as a beacon to help find the radio.
NOTE: The radio plays this alert tone even in Surveillance Mode.
When the alert tone is active, changing to another channel with a different setup triggers a different
response from the radio:
• The alert tone is inhibited when you change to a channel without Emergency feature.
• The alert tone is inhibited when you change to a channel with Emergency but no Fall Alert feature.
• The current alert tone is inhibited and is replaced with a different alert tone when you change to a
channel with Emergency feature and a different Fall Alert configuration.
• The alert tone continues when you change to a channel with Emergency and similar Fall Alert
configuration.
7.13.2
Testing Fall Alert
Prerequisites: Ensure that Fall Alert feature is configured in your radio.
Procedure:
1 Turn on the radio, and place it in a vertical position for at least 5 seconds.
2 Lay the radio down in a horizontal position.
The radio plays an alert tone and the display shows Man-Down.
The radio plays an alert tone and the display shows Fall Alert Detected.
Postrequisites: If Fall Alert is configured but the condition does not trigger the activation of the
feature, send the radio to a qualified technician.
7.13.3
Exiting Fall Alert
Procedure:
To exit Fall Alert mode, press Clr.
7.13.4
Reinitiating Fall Alert
Procedure:
To reinitiate Fall Alert after exiting Emergency Operation, perform one of the following actions:
• Return the radio to a vertical position.
• If motion sensitivity is enabled, shake the radio.
MN002667A01-AV
Chapter 7 : Advanced Features
57
To Next Page
Loading...
Need help?
General
