7.9.5
Remote Emergency
The Remote Emergency feature allows you to remotely launch the emergency feature on a target
radio.
You can send the Remote Emergency request to radios from recently transmitted or received calls that
are stored. The latest Recent Call List refreshes automatically on your radio.
7.9.5.1
Receiving Remote Emergency
The remote emergency will only be launched if your radio has the emergency enabled. The receiving
radio displays Emergency.
Procedure:
To exit the emergency operation, press and hold the programmed Emergency button.
7.9.6
Sending an Emergency Alarm
When and where to use: This feature allows you to send a data transmission, which identifies the
radio sending the emergency, to the dispatcher.
NOTE: The default timer of Emergency button press to activate Emergency is 50 milliseconds.
This timer is programmable from 50–6200 milliseconds by a qualified technician.
Procedure:
Press the preprogrammed Emergency button.
One of the following scenarios occurs:
• The display shows EMERGENCY and the current zone or channel. You hear a short medium-
pitched tone and the LED blinks red momentarily.
• The radio sounds a short low-pitched tone to indicate that the selected channel does not
support emergency and rejects to launch emergency mode.
When you receive the dispatcher’s acknowledgment, the display shows ACK RCVD. Four tones sound,
the alarm ends, and the radio exits the Emergency Alarm mode.
If no acknowledgment is received, the display shows NO ACK. The alarm ends and the radio exits the
Emergency Alarm mode.
7.9.7
Sending an Emergency Call (Trunking Only)
When and where to use: This feature gives your radio priority access to a talkgroup.
Procedure:
1 Press the preprogrammed Emergency button.
One of the following scenarios occurs:
• The display shows EMERGNCY and the current zone or channel. You hear a short medium-
pitched tone and the LED blinks red momentarily.
MN002667A01-AV
Chapter 7 : Advanced Features
50
To Next Page
Loading...
Need help?
General
