1-1
Motorola Confidential Proprietary
Draft 1.0
3G Flash
Procedures
Introduction
This document is intended to describe the flashing (firm-
ware upgrade) procedures for 3G terminals. The 3G
terminal described in this document will be limited to
the V975, V980, C975, and C980.
Firmware upgrades need to be handled in a controlled
manner. Carrier software approvals need to be consid-
ered before initializing a flashing procedure. Consult a
Motorola representative to ensure that the firmware
upgrade application database is up-to-date.
Firmware upgrades allows the service organization to
resolve field software issues that customers may be ex-
periencing. Some issues may pertain to specific circum-
stances, therefore, not all units will contain identical soft-
ware versions.
Hardware Requirements
The following hardware will be required to properly
flash the 3G terminal.
Power Hardware
1. Fully Charged battery (SNN5743A or equiva-
lent)
2. Full-rate Charger (SPN5049 or equivalent)
Interface Options
1. USB Data Kit (S8951)
USB Cable (SKN6311A)
Data Software CD
Software Requirements
The RSD (Remote Software Download) General Re-
lease is used to allow functions such as firmware up-
grade, Phone Swap, and Multi-refurbish. Contact your
local Motorola service representative to receive down-
load information for the RSD and related support files.
Also insure that the RSD database has the latest up-
date.
To Next Page
Loading...
Need help?
General
