Motorola Confidential Proprietary
V975/V980/C975/C9803G Flash Procedures
1-2
Draft 1.0
Flashing
Before beginning any flashing procedure, always insure
that all hardware connections are secured. Refer to fig-
ure 1-1 for flash connection guides. Any intermittent
hardware connections may cause the procedure to fail
and result in a nonfunctional (Bricked) 3G terminal.
Power Solutions
There are two types of power solutions to perform a
flashing procedure.
1. Fully Charged Battery
2. Full-Rate Charger w/battery (recommended)
If the user decides on using the battery only solution,
he/she must verify that the battery is fully charged. Fail-
ing to verify the capacity of the battery may result in
battery depletion prior to completing the flash process.
This action may cause unrecoverable failures to the 3G
terminal.
RSD Firmware Upgrade Procedure
Use the listed procedure to complete the flash proce-
dure for a 3G terminal.
1. Launch the RSD General application
2. Connect the unit as illustrated in figure 1-1.
3. Power up the 3G terminal
4. If the 3G terminal doesn’t power up, refer to
the Force Flash section.
5. Once the phone is fully powered up, the Radio
Information Panel will be updated.
7. In the Utilities Panel, select Firmware Upgrade.
8. In the Main information Panel, select desired
restore and logging options
9. In the Main information Panel, click on the Start
button to begin Firmware upgrade.
NOTE: DO NOT interrupt any hardware connections
during the flash process. Connection interrup-
tions may cause the flashing process to fail and
render the 3G terminal non-operational.
10. When the process is complete, the Main Infor-
mation Panel will indicate whether the process
was successful. At this time you may safely dis-
connect the 3G terminal.
11. Power up the 3G terminal to insure that the flash
procedure was successful.
Flashing
To Next Page
Loading...
Need help?
General
