MTS Systems Exceed 40 Series User Manual

Routine Maintenance Overview Checklist
MTS Exceed™ Series 40 Product Manual Maintenance
75
Maintenance
Routine Maintenance Overview Checklist
Recommended Service
C ALENDAR T IME U SING 8 H OURS R UNNING T IME
R ATE PER D AY
D AILY W EEKLY A NNUALLY
R UNNING T IME -H OURS 8 40 2000
Check shunt calibration
X
*
Clean work area/machine surface X
Activate and reset limits and Emergency-Stop X
Inspect cable/connections X
PC Maintenance
Back up testing software files (*.reg/.cal files)
MTS
†
Hard drive defragment MTS
System Inspection
Check/adjust drive belt tension (refer to table) MTS
Inspect drive belts for excessive wear MTS
Inspect cable connections MTS
System Checks
Check Emergency-Stop MTS
Check upper limit MTS
Check lower limit MTS
Check load cal/shunt cal MTS
Lubrication
Crosshead/ball screw (#2 white lithium grease) MTS
Drivetrain bearings (if applicable) MTS
Frame and Work Area
Clean off frame and work area MTS
* Denotes services performed by equipment operators. Most of these procedures involve visual checks
that should not interfere with testing system operation. These checks are also completed by trained
field service engineers on each Routine Maintenance visit.
† Denotes service performed by trained field service engineers as part of an MTS Routine Maintenance
plan. Some of these procedures require special service tools and/or specific service training to
complete.
0Exceed product manual.book Page 75 Wednesday, August 27, 2014 2:55 PM

MTS Systems Exceed 40 Series Specifications

General

Brand	MTS Systems
Model	Exceed 40 Series
Category	Test Equipment
Language	English