DECT system configuration
50
Subscribing the handset to a DECT system
You must subscribe the handset to at least one DECT system before
you can use the handset to make a call. The handset can operate with
a maximum of four DECT systems, for which the handset stores the
name of the system in a subscription record. The subscribed name
appears on the handset display whenever the handset enters the range
of the DECT system.
If your supplier preinstalls the handset, you need not subscribe your
handset to a system. When the handset is not yet subscribed to a
system, the message Register appears on the display screen.
Use the PABX-PIN code to register the handset with a DECT system.
Before you subscribe to a DECT system, obtain the following
information from your system administrator:
1. PARK code: Use a PARK code system ID only if more than one
DECT system overlaps in your location.
2. DECT system name: The name of the system to which you
subscribe. After you enter the system name, it appears on the idle
display.
3. Phone number: The local phone number assigned to your DECT
handset.
To subscribe your handset to a DECT system, perform the following
steps:
To Next Page
Loading...
Need help?
General
