TIP
Set the stop time earlier than the start time so that the period extends
beyond midnight. Scheduling then stops at the set stop time the day
after.
Scheduling always starts on the date that the start time is set for.
ADVANCED
Menu advanced has orange text and is intended for the advanced user. This
menu has several sub-menus.
Menu
1.9
curve Setting the curve slope for heating and cooling.
external adjustment Setting the heat curve offset when the external contact is
connected.
min. flow line temp. Setting minimum permitted flow line temperature.
room sensor settings Settings regarding the room sensor.
cooling settings Settings for cooling.
own curve Setting own curve for heating and cooling.
point offset Setting the offset of the heating curve or cooling curve at a specific
outdoor temperature.
night cooling Setting night cooling.
+Adjust Setting how much effect +Adjust will have on calculated supply tem-
perature for underfloor heating. The higher the value is the greater the effect.
31Chapter 3 | VVM 320 – at your serviceNIBE VVM 320
To Next Page
Loading...
Need help?
General
