Nibe VVM 320 User Manual

PROXY SETTINGS
confirm reset
proxy settings 4.1.3.9
use proxy
server
port
user name
password
You can set proxy settings for your install-
ation here.
Proxy settings are used to give connection
information to a intermediate server (proxy
server) between the installation and Inter-
net. These settings are primarily used
when the installation connects to the Inter-
net via a company network. The installa-
tion supports proxy authentication of the
HTTP Basic and HTTP Digest type.
Menu
4.1.3.9
If unsure about applicable settings, contact your network administrator (or similar)
for further information.
Setting
1.
Tick “use proxy" if you do not want to use a proxy.
2.
Mark “server" and press the OK button.
3.
Enter the correct details via the virtual keypad.
4.
Mark “OK" and press the OK button.
5.
Repeat 1 - 3 for "port", "user name" and "password".
6.
Mark “confirm" and press the OK button.
TIP
All settings made since opening the menu can be reset by marking
"reset" and pressing the OK button.
SMS (ACCESSORY IS REQUIRED)
phone number
alarm receiver
sms 4.1.4
Make settings for the accessory SMS 40
here.
Add the mobile numbers that are to have
access to change and receive status in-
formation from the indoor module. Mobile
numbers must include country code e.g.
+46 XXXXXXXX.
If you want to receive an SMS message
in the event of the alarm mark the box to
the right of the telephone number.
Menu
4.1.4
59Chapter 3 | VVM 320 – at your serviceNIBE VVM 320

Nibe VVM 320 Specifications

General

Brand	Nibe
Model	VVM 320
Category	Control Unit
Language	English