Nice POP PP7124 Instructions And Warnings For Installation And Use

EN
8 – English
Note – The factory settings are highlighted in grey.
L8 L1
L2
L3
L4
L5
L6
L7
L8
Manoeuvre 1 result (most recent)
Manoeuvre 2 result
Manoeuvre 3 result
Manoeuvre 4 result
Manoeuvre 5 result
Manoeuvre 6 result
Manoeuvre 7 result
Manoeuvre 8 result
The type of fault that has occurred in
the last 8 manoeuvres can be establi-
shed
See TABLE 12 – Fault log.
List of
faults
TABLE 8 - Programming procedure second level functions
01. Press and hold down the “Set” key for approx. 3 seconds.;
02. Release the key when LED “L1” starts flashing;
03. Press the “” or “u” key to move the flashing LED to the LED representing the “input LED” of the parameter to be modified;
04. Press and hold the “Set” key through to completion of point 06;
05. Wait approx. 3 seconds, until the LED representing the current level of the parameter to be modified illuminates;
06. Press keys “” or “u” to move the LED representing the value of the parameter;
07. Release the “Set” key;
08. Wait 10 seconds (maximum time) to exit the programming mode.
Note – During this procedure, points 03 to 07 need to be repeated when programming other parameters during the phase itself .
SET
SET
SET
SET
L1
or
or
3 s
10 s
6.3 - Special functions
6.3.1 - Function: “Move anyway”
This function allows the automation to be operated even when any of the safe-
ty devices does not work correctly or is out of use.
The automation can be controlled in the “hold-to-run”, mode. Proceed as fol-
lows:
01. Send a command to operate the gate using a transmitter or a key selector,
etc. If everything operates correctly, the gate will move normally, otherwise
proceed as follows;
02. within 3 seconds, activate the control again and keep it activated;
03. after approximately 2 seconds, the gate will perform the required move-
ment in “hold-to-run”; mode; i.e. the gate will continue to move only as
long as the control is activated.
If the safety devices do not operate, the flashing light flashes a few times to indi-
cate the kind of problem (see chapter 6 - Table 10).
6.3.2 - Function: “Maintenance warning”
This function serves to indicate when automation maintenance is required. The
maintenance warning signal is emitted by a lamp connected to the “flash” or
“els” output when this output is programmed as a “maintenance indicator light”
The various light signals are shown in Table 9.
To program the limit value of the maintenance operations, see Table 7.
6.4 - Deleting the memory
To delete the control unit memory and restore all factory settings, proceed as
follows:
press and hold keys “” and “u” until leds L1 and L2 start flashing.
TABLE 9 - “Maintenance light”
Number of manoeuvres Signal
Below 80% of the limit
Between 81% and 100% of the limit
Beyond 100% of the limit
Light on for 2 seconds at the start of the opening manoeuvre.
Light flashing for the entire duration of the manoeuvre.
Light flashing continuously.

Nice POP PP7124 Specifications

General

Brand	Nice
Model	POP PP7124
Category	Gate Opener
Language	English