Caring
for
the
Camera
Cleaning
Lens
Monitor
Body
lAvoid
touching
glass
parts
with
your fingers. Remove dust or lint
with
a blower
I
(typically a small device
with
a rubber bulb attached
to
one end that
is
pumped
to
produce a stream
of
air
out
the other end).
To
remove fingerprints
I or other stains that cannot be removed
with
a blower, wipe the lens
with
a soft
I
cloth, using a spiral
motion
that starts at the center
of
the lens and working
• toward the edges. If this
fails,
clean the lens using a cloth lightly dampened
. with commercial lens cleaner.
Remove dust or lint
with
a blower.
To
remove fingerprints and other stains,
clean the
monitor
with a soft, dry cloth, being careful
not
to
apply pressure.
Use
a blower
to
remove dust, dirt or sand, then wipe gently
with
a soft/ dry
cloth. After using the camera at the beach or
seaside,
wipe
off
any sand or
salt
with
a dry cloth lightly dampened
with
fresh water, then dry thoroughly. Note
that foreign matter inside the camera could cause damage
not
covered by the
warranty.
108
Do
not
use
alcohol, thinner, or other volatile chemicals.