Getting started
4
5. Slide the back cover into its place.
■ Charging the battery
1. Attach the
lead from
the charger
carefully to
the socket
(1.)
on the bottom of your phone.
NOTE:
Connector
(2.)
is the
headset connector. Do not plug
your headset in the charger
connector. It may damage the
charger connector.
2. Connect the charger to an
AC wall outlet. The battery
indicator bar starts to scroll.
The text
Charging
is briefly
displayed if the phone is
switched on. You can use the
phone while charging.
NOTE:
If the battery is totally
flat, it may take a few minutes
before the charging indication
appears on the display or any
calls can be made. The charging
time depends on the charger and
battery used. For example,
charging a BLB-2 battery with
the ACP-8 charger takes about 1
hour and 40 minutes.
3. The battery is fully charged when
the battery indicator bar stops
scrolling. If the phone is on, the
text
Battery full
is also briefly
displayed.
4. Disconnect the charger from the
AC outlet and the phone.
If
Not charging
is displayed,
charging has been suspended. Wait
for a while, disconnect the charger
and plug it in again. If charging still
fails, contact your dealer.
For more information, see chapter
‘Reference Information’ - ‘Battery
Information’.
■ Switching the phone on
and off
Press and hold the power key.
If the phone requests a PIN code
• Key in the PIN code, which is
displayed as asterisks Q, and
press
OK
.
See also ‘Reference Information’
- ‘Access Codes’.
1
2
To Next Page
Loading...
Need help?
General
