Connect a UPS to a G-2426G-B ONT
3FE-49441-ABAA-TCZZA
Issue 1
Figure 6-13 G-2426G-B ONT and PSI UPS
Battery
Mute
DC
System Status
Alarm silence
Cold start
Reset
UPS
connector
3-prong
AC
plug
Output
connector
Molex
DC
cable
AC
power
cable
36155
The
following figure shows
an
example
ONT and
UPS.
The
position
of the
connections
may differ for each ONT
model
3
Remove the back cover to expose the battery connectors.
Slide Battery pack onto Power Supply/Charger unit until the Battery Pack becomes fully flushed
with Power Supply/ Charger as shown in Figure 6-14, “Battery pack onto Power Supply/Charger”
(p. 84).
You should hear a click when battery pack is fully seated.
The UPS can remain on the desk or be placed on the floor underneath the desk.
Two battery extensions are needed for 8 hours of emergency support calls. Four battery
extensions are needed for 24 hours of emergency support calls.
Install the UPS back cover in the bottom of the last battery module to protect the connectors to
additional batteries.
To Next Page
Loading...
Need help?
General
