- 10 -
When installing or moving
WARNING
For the U.S.A. and Canada
Multifunctional Digital Systems require 110 to 127 V, 10 A, 50/60 Hz electric power.
For the EU
Multifunctional Digital Systems require 220 to 240 V AC, 5 A, 50/60 Hz electric power.
Except the U.S.A., Canada and the EU
Multifunctional Digital Systems require 220 to 240 V AC, 5 A, 50/60 Hz electric power.
Do not use a power supply with a voltage other than that specied.
Avoid multiple connections in the same outlet. This could cause a re or give you an electric shock. If
you are considering increasing the number of outlets, contact an electrician.
Always connect this machine to an outlet with a ground connection to avoid the danger of re or
electric shock in case of short-circuiting. Contact your service representative for the details. Be sure
to use a 3-conductor, grounded wall outlet.
In areas, except the U.S. and Canada, where a 2-pin plug is used, the machine must be grounded for
safety. Never ground it to a gas pipe, a water pipe, or any other object not suitable for grounding.
Plug the power cord securely into the outlet. If it is not plugged in properly, it could heat up and
cause a re or give you an electric shock.
Do not damage, break or attempt to repair the power cord.
The following things should not be done to the power cord.
_
Twisting it
_
Bending it
_
Pulling it
_
Placing anything on it
_
Heating
_
Situating it near radiators or other heat sources
This could cause a re or give you an electric shock. If the power cord is damaged, contact your
dealer.
The socket outlet shall be near the equipment and be easily accessible.
Pull out the plug from the outlet more than once a year to clean around the prongs. Accumulating
dust and dirt could cause a re due to the heat released by electric leakage.
To Next Page
Loading...
Need help?
General
