- 13 -
Other points
Be very careful to treat the touch panel gently and never hit it. Breaking the surface could cause
malfunctions.
Be sure to turn the power OFF when leaving the ofce or if there is a power outage. However, do not
turn the power OFF if the weekly timer is in use.
Be careful because the paper exit area and paper just after exiting are hot.
Do not place anything other than paper on the receiving tray. This could disturb a normal operation
and cause malfunctions.
Do not touch the photoconductive drum and transfer belt. This could cause image problems.
Do not open/close the covers and the MPT, or pull out the trays during printing.
During maintenance or inspection
WARNING
Never attempt to repair, disassemble or modify the machine by yourself. You could cause a re or get
an electric shock.
Do not let liquids such as water and oil get into the machine when cleaning the oor. This could cause
a re and give you an electric shock.
CAUTION
Always keep the plug and outlet clean. Prevent them from accumulating dust and dirt. This could
cause a re and give you an electric shock due to the heat released by electric leakage.
Do not touch the stapling area. The actual needle point could cause you personal injury.
Other points
Do not use such solvents as thinner or alcohol when cleaning the surface of the machine.
_
This could warp the shape of the surface or leave it discolored.
_
When using a chemical cleaning pad to clean it, pay attention to any cautionary points.
To Next Page
Loading...
Need help?
General
