Paper handling > 30
E
JECTING
CUT
SHEET
PAPER
When the printer reaches the end of the cut sheet page it automatically ejects the page. If
required, add another sheet for the printer to continue printing from where it left off.
To eject a cut sheet left in the printer, carry out the following:
1. Press the SEL button to put the printer off-line.
2. Press the LOAD/EJECT button and the paper is ejected to the Paper Tray.
C
HANGING
PAPER
PATHS
You can switch to cut sheet printing without removing continuous forms from the printer.
Continuous forms to cut sheet
1. Tear the continuous form at the tear off position.
2. Press the LOAD/EJECT button. The printer will retract the continuous form
automatically and set the printer in offline mode.
3. Set the Paper Type Lever to Cut Sheet.
4. To load cut sheet paper, see “Loading cut sheet paper” on page 28.
Cut sheet to continuous forms
1. Remove any cut sheet paper in the printer.
2. Set the Paper Type Lever to Continuous form (REAR or FRONT or PULL).
3. To load continuous forms, see “Loading continuous forms” on page 18.
NOTE
Paper longer than A4 length (297 mm) may overlap and possibly fall off the
Paper Tray.
To Next Page
Loading...
Need help?
General
