Omron CJ - INSTRUCTIONS User Manual

161
3. Instructions
CS/CJ/NSJ Series Instructions Reference Manual (W474)
Sequence Output Instructions
3
TR
z TR0 to TR15 Considerations
TR bits are used only for retaining (OUT TR0 to TR15) and restoring (LD TR0 to TR15) the ON/OFF
status of branching points in programs with many output branches. They are thus different from general
bits, and cannot be used with AND or OR instructions, or with instructions that include NOT.
z TR0 to TR15 output Duplication
A TR bit address cannot be repeated within
the same block in a program with many output
branches, as shown in the following diagram.
It can, however, be used again in a different
block.
to
0.00
0.10 0.11
0.15 1.00
1.01
0.14
0.13
0.12
0.04
0.03
0.02
5.00
5.01
5.02
6.00
6.01
6.02
6.03
6.04
0.01

Omron CJ - INSTRUCTIONS Specifications

General

Brand	Omron
Model	CJ - INSTRUCTIONS
Category	Controller
Language	English