Omron CS Series User Manual

150
Communicating between OMRON PLCs Section 6-6
CPU Bus Unit Service Processing Time (Local Node)
The processing time will be as follows, depending on the CPU processing
mode settings at the CPU Unit:
For details, refer to the CPU Unit operation manual.
Transmission Processing Time
Number of words sent x 0.002 + 0.550 ms
Transmission Delay
The transmission delay time will be as given below, depending on the baud
rate set for the Ethernet Unit. (There may be additional delays depending on
devices, such as hubs, in the network configuration.)
Reception Processing Time
Number of words sent × 0.003 + 0.704 ms
CPU Bus Unit Service Cycle (Remote Node)
The processing time will be as follows, depending on the CPU processing
mode settings at the CPU Unit.
For details, refer to the CPU Unit operation manual.
CPU execution mode Processing time considerations
Normal Mode Set time for peripheral servicing
(Default: 4% of CPU Unit cycle time)
Priority peripheral servicing
Parallel processing with synchro-
nous memory access
Parallel processing with asynchro-
nous memory access
1 ms max.
Baud rate Delay time
100Base-TX Number of words sent × 0.0013 + 0.0118 ms
10Base-T Number of words sent × 0.0019 + 0.0157 ms
CPU processing
mode settings
Processing time considerations
Normal Mode CPU Unit cycle time
Priority peripheral ser-
vicing
Ethernet Unit is given
priority.
Time slice instruction execution
time
Ethernet Unit is not
given priority.
CPU Unit cycle time
Parallel processing with
synchronous memory
access
CPU Unit cycle time
Parallel processing with
asynchronous memory
access
0.2 ms + peripheral servicing time (1 ms max. of peripheral
servicing time for each Special I/O Unit, CPU Bus Unit,
peripheral port, RS-232C port, or Inner Board)

Omron CS Series Specifications

General

Brand	Omron
Model	CS Series
Category	Network Hardware
Language	English