Omron E5CN-H Communications Manual

SYSWAY
SECTION 4 SYSWAY (E5@J and E5@X Format) Communications Procedures
4-6
• Alarms 1 and 2: Cleared
Note 1. Heater burnout is the status corresponding to heater burnout 1
(CT1).
(3) End Code
When the end code is “00,” this indicates normal completion of the
command. Otherwise, the command could not be processed. For
details on end codes, see Response Frame on page 4-3.
(4) Precautions
• Even though alarms 1 and 2 are not displayed on the Controller
display, they function normally in communications.
■ Write Set Values This command writes the set point, alarm values 1 and 2, proportional
band, integral time, derivative time, temperature input shift values, and
heater burnout detection.
Command
Response
(1) Header Code
(2) Data Code
Set the data code to “02” only when writing alarm value 2. In all other
cases, set to “01.”
(3) Write Value
For details on the write value (set value) range, see SECTION 3
Communications Data for CompoWay/F and SYSWAY.
(4) Precautions
● Alarm Values 1 and 2
Header code Command
WS Write set point
W% Write alarm value 1/2
WB Write proportional band
WN Write integral time
WV Write derivative time
WI Write temperature input shift values
WW Write heater burnout detection
@
FCS
CR
*
Communi-
cations
unit num-
ber
Header
code
Termi-
nator
Data
code
Write
value
@
FCS
CR
*
Communi-
cations
unit num-
ber
Header
code
Termi-
nator
End
code

Omron E5CN-H Specifications

General

Brand	Omron
Model	E5CN-H
Category	Controller
Language	English