Omron E5CN-H Communications Manual

SYSWAY
4.2 Command Descriptions
4-9
● Alarm
• Even when alarms 1 and 2 are not displayed on the Controller's
display, they function normally in communications.
• Only alarms 1 and 2 are supported.
• Alarm 3 cannot be used.
● Heater Burnout Detection
Reads the Heater Burnout Detection 1 parameter. (The Heater Burnout
Detection 2 parameter value is not read.)
■ Select Communications Writing
The logic of the MB command changes as shown in the table below
according to the MB command logic switching setting (advanced
function setting level). The MB command (communications writing
selection) is equivalent to the E5@J Controller’s MB command (remote/
local switching).
• The default value of the MB Command Logic Switching Setting is OFF
(same logic as E5@J).
Text data of MB
command
MB command logic switching setting
OFF ON
0000
Communications writing
enabled (remote mode
selection)
Communications writing
disabled (local mode
selection)
0001
Communications writing
disabled (local mode
selection)
Communications writing
enabled (remote mode
selection)

Omron E5CN-H Specifications

General

Brand	Omron
Model	E5CN-H
Category	Controller
Language	English