238
Parameter Structure
Section 6-1
6-1 Parameter Structure
• To execute user calibration, enter the password “1201” at the Move to Cal-
ibration Level parameter in the advanced function setting level. The mode
will be changed to the calibration mode, and adj will be displayed.
• The Move to Calibration Level parameter may not be displayed when the
user is doing the calibration for the first time. If this happens, set the Initial
Setting/Communications Protect parameter in the protect level to 0 before
moving to the advanced function setting level.
• The calibration mode is ended by turning the power OFF.
• The parameter calibrations in the calibration mode are structured as
shown below.
Controllers with Thermocouple/Resistance Thermometer Universal Inputs
19: K140F/60C
20: K240F/120C
21: K280F/140C
22: K440F/220C
24: W
25: PL II
5: K
7: J
11: E
12: L
15: N
6: K
8: J
9, 10: T
13, 14: U
16: R
17: S
18: B
1: Pt100
2: Pt100
3: JPt100
4: JPt100
0: Pt100 23: 0 to 50 m
To Next Page
Loading...
Need help?
General
