Orientation of Product
• For good heat dissipation, install the product only in the position written this manual or Instruction
sheet so as not to block the ventilation holes.
Ambient Temperature
• For good heat dissipation, keep the distance written this manual or Instruction sheet.
• Do not install the product immediately above significant heat sources, such as heaters, transform-
ers, or large-capacity resistors.
• Do not let the ambient temperature exceed an operating temperature range.
• Provide a forced-air fan cooling or air conditioning if the ambient temperature is near the upper
range of operating temperature range so that the ambient temperature never exceeds the upper
range of operating temperature range.
Noise Resistance
• Do not install the product in a cabinet containing high-voltage equipment.
• Do not install the Sensor Controller within 200 mm of power cables.
Component Installation and Handling (FH series)
• Touching Signal Lines
To prevent damage from static electricity, use a wrist strap or another device for preventing electro-
static discharges when touching terminals or signal lines in connectors.
• Handling a USB Memory/SD memory card.
Refer to 9-1-3 Using External Storage Devices on page 9 - 5.
• Do not insert an SD memory card in the reverse orientation, at an angle, or in a twisting manner.
Before removing a USB memory device or SD memory card, make sure that data is not being read
or written to them.
For a USB memory device, the memory device's LED flashes while data is being read or written.
Make sure that the LED stops flashing before removing the memory device.
For an SD memory card, the SD BUSY LED of Sensor Controller flashes while data is being read or
written. Make sure that the LED stops flashing before removing the card.
• Turning OFF the Power
When a message is displayed indicating that a task is in progress, do not turn OFF the power. Doing
so causes the data in the memory to be corrupted, resulting in the product not operating properly
upon the next start-up.
When turns OFF, conform the followings proceedings have completed. and then operate again.
- When saves using Sensor Controller: Confirm the save processing is completed and next opera-
tion is possible.
- When saves using communication command: Intended command is completed. BUSY signal is
turned OFF.
• Setting of Power Source
The power source need to be supplied from DC power source apparatus which is taken a save ultra-
low voltage circuit: to protect high voltage.
Precautions for Correct Use
26
FH/FHV Series Vision System User’s Manual (Z365-E1)
To Next Page
Loading...
Need help?
General
