5
In the RUN mode, this button terminates the measurement process and allows
you to enter the setting mode, advancing through the menus and parameters.
Menu 1 Menu 2
Menu n
Parameter 1 Parameter 2 Parameter n
In the setting mode, this button will store changes in the non-volatile memory
while at the same time advancing the display to the next menu item.
Used to select a parameter to be displayed for setting value change.
Used to increment the current digit in the setting value by one.
The value increases in the following order:
0, 1, 2, 3, 4, 5, 6, 7, 8, 9, (–1), and (–)
Only the leftmost digit will be displayed if the value is set to “–1” or“ –.”
The value will be set to 0 if this key is pressed when “9” or “–” is displayed.
Used to change the parameter displayed in setting mode.
Used to scroll the digit to the right of the presently displayed digit.
Used to set the process value forcibly to “0” or reset the maximum/minimum
value in RUN mode.
Used to select the teaching function. Refer to 5-1 Teaching Function for details.
Up Key
Shift Key
RESET/TEACH Key
Front of the Meter
Section 1-2
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
To Next Page
Loading...
Need help?
General
