Omron NJ Series Network Connection Guide

7. Connection Procedure
18
7.2. Work Flow
Take the following steps to set the tag data link for EtherNet/IP.
7.3 Setting Up the Displacement
Sensor
Set up the Displacement Sensor.
↓
7.3.1 Parameter Settings
Set the parameters for the Displacement Sensor.
↓
7.4 Setting Up the Controller
Set up the Controller.
↓
7.4.1 Starting the Sysmac Studio and
Importing the Project File
Start the Sysmac Studio, and import the Sysmac
Studio project file.
↓
7.4.2 Connecting Online and
Transferring Project Data
Connect online with the Sysmac Studio and transfer
the project data to the Controller.
↓
7.5 Setting Up the Network
Set tag data links for EtherNet/IP.
↓
7.5.1 Starting the Network
Configurator and Opening the
Network Configuration File
Start the Network Configurator and open the
Network Configurator v3 network configuration file.
↓
7.5.2 Transferring the Tag Data Link
Settings
Connect the Network Configurator online and
transfer the tag data link settings to the Controller.
↓
7.6 Checking the EtherNet/IP
Communications
Confirm that the EtherNet/IP communications are
performed normally.
↓
7.6.1 Checking the Connection Status
Check the connection status of the EtherNet/IP
network.
↓
7.6.2 Checking Data that are Sent and
Received
Confirm that the correct data are sent and received.

Omron NJ Series Specifications

General

Brand	Omron
Model	NJ Series
Category	Controller
Language	English