Omron SMARTSTEP 2 SERIES User Manual

3-48
3-4 Cable and Connector Specifications
3
Specifications
 Connector-Terminal Block Conversion Unit
By using the Connector-Terminal Block Conversion Unit in combination with a Connector Terminal
Block Cable (XW2Z-@J-B28), the Servo Drive's Control I/O Connector (CN1) can be converted to
a terminal block.
XW2B-34G4 (M3 screw terminal block)
 Dimensions
 Use 0.30 to 1.25 mm
2
wire (AWG22 to AWG16).
 The wire slot is 1.8 mm (height) × 2.5 mm (width).
 Strip the insulation from the end of the wire for 6 mm as shown below.
3.5
29.5
Flat cable connector (MIL plug)
3.5
112.5
45
15.5
Two,
3.5 dia.
Terminal block
5.08
20.5
38.1
(45.3)
Precautions
for Correct Use
6 mm

Omron SMARTSTEP 2 SERIES Specifications

General

Brand	Omron
Model	SMARTSTEP 2 SERIES
Category	DC Drives
Language	English