Omron SMARTSTEP 2 SERIES User Manual

5-19
5-10 User Parameters
5
Operating Functions
5. Saving the New Setting to Memory
6. Returning to the Display of Parameter Write Mode
Key operation Display example Explanation
Press the Mode key to display Parameter Write Mode.
Press the Data key to move on to Parameter Write Mode.
Press the Increment key for at least 5 s.
The bar indicator will appear.
Writing will start. (This display will appear only momentarily.)
This display indicates a normal completion. In addition to “Finish,” either
or may be displayed.
If is displayed, writing has been completed normally, but some
of the changed parameters will be enabled only after the power is turned ON
again. Turn OFF the Servo Drive power supply and then turn it ON again.
If is displayed, there is a writing error. Write the data again.
ekek_kskektk
ekekpk k k-.
ekekpk k-k-.
-k-k-k-k-k-.
sktkakrktk k
finish.
reset . error .
reset .
error .
Key operation Display example Explanation
Press the Data key to return to the display of Parameter Write Mode.
ekek_kskektk

Omron SMARTSTEP 2 SERIES Specifications

General

Brand	Omron
Model	SMARTSTEP 2 SERIES
Category	DC Drives
Language	English