7
Precautions for Safe Use
îš„ Storage and Transportation Precautions
Do not place any flammable materials near the Servomotor, Servo Drive, or Regeneration
Resistor.
Doing so may result in fire.
Mount the Servomotor, Servo Drive, and Regeneration Resistor on metal or other non-
flammable materials.
Not doing so may result in fire.
Do not turn ON/OFF the main power supply of the Servo Drive repeatedly at frequent
intervals.
Doing so may result in product failure.
Use the Servomotors and Servo Drives in a combination as specified in the manual.
Not doing so may result in fire or damage to the products.
Do not store or install the product in the following places. Doing so may result in fire, electric
shock, or damage to the product.
 Locations subject to direct sunlight.
 Locations subject to ambient temperature exceeding the specified level.
 Locations subject to relative humidity exceeding the specified level.
 Locations subject to condensation due to temperature fluctuations.
 Locations subject to corrosive or flammable gases.
 Locations subject to dust (especially iron dust) or salt.
 Locations subject to exposure to water, oil, or chemicals.
 Locations subject to shock or vibration.
Do not touch the Servo Drive radiator, Regeneration Resistor, or Servomotor while the
power is being supplied or for some time after the power is turned OFF.
Doing so may result in burn injuries.
Do not hold the product by the cables or motor shaft while transporting it.
Doing so may result in injury or malfunction.
Do not overly pile the products. (Follow the instructions on the product package.)
Doing so may result in injury or malfunction.
WARNING
Caution
Caution
To Next Page
Loading...
Need help?
General
