Omron SYSMAC NX-CIF105 User Manual

A - 43
Appendices
NX-series Communications Interface Units User’s Manual (W540)
A-6 Version Information with Communica-
tions Coupler Units
A
A-6-1 Connection to an EtherCAT Coupler Unit
A-6 Version Information with Communica-
tions Coupler Units
This section provides version-related information when connecting Units to a Communications Coupler
Unit. Version information is provided separately for each Communications Coupler Unit that an NX Unit
is connected to.
The relationship between the unit versions of each Un
it, EtherCAT Coupler Unit, CPU Unit and Indus-
trial PC, and versions of the Sysmac Studio are shown below.
The items that are used in the version combination tables are given below.
The version combination table is given below.
• With the combinations of the unit versions/versions sh
own below, you can use the functions that are
supported by the unit version of the Unit model. Use the unit versions/versions (or the later/higher
unit versions/versions) that correspond to the NX Unit models and the unit versions. You cannot use
the specifications that were added or changed for the relevant NX Unit models and the unit versions
unless you use the corresponding unit versions/versions.
• Depending on the type and model of the Unit to which the
NX U
nit is connected, some Units do not
have the corresponding versions given in the table. If a Unit does not have the specified version, sup-
port is provided by the oldest available version after
the specified version. Refer to the user’s manu-
als for the specific Units for the relation between models and versions.
• If you use the corresponding unit versions/versions given
in the following table or later/higher ver-
sions, refer to the vers
ion information in the user’s manual for the Communications Coupler Unit,
CPU Unit, and Industrial PC.
A-6-1 Connection to an EtherCAT Coupler Unit
Relationship between Unit Versions of Units
NX Unit Corresponding unit versions/versions
Model Unit version
EtherCAT Coupler
Unit
CPU Unit or Indus-
trial PC
Sysmac Studio
Model number of NX
Unit
Unit version of the
NX Un
it
Unit version of Eth-
erCAT Coupler Unit
th
at is compatible
with the NX Unit
Unit version of
NJ/N
X-se
ries CPU
Unit or NY-series
Industrial PC that is
compatible with the
EtherCAT Coupler
Unit
Sysmac Studio ver-
sion that is compati-
ble with the NX Unit,
EtherCAT Coupler
Unit, C
PU Unit, and
Industrial PC
NX Unit Corresponding unit versions/versions
Model Unit version
EtherCAT Coupler
Unit
CPU Unit or Indus-
trial PC
Sysmac Studio
NX-CIF101 Ver.1.0 Ver.1.0
Ver.1.11
*1
*1. The serial communications instructions for the CIF Units can be used with CPU Units or Industrial PCs with
unit version 1.11 or later. You can connect a CIF Unit to a CPU Unit or Industrial PC with unit version 1.10, but
if you do, you cannot use the serial communications instructions for the CIF Units. Refer to the instructions
reference manual for the connected CPU Unit or Industrial PC for information on serial communications in
-
structions for CIF Units.
Ver.1.15
NX-CIF105
NX-CIF210

Omron SYSMAC NX-CIF105 Specifications

General

Brand	Omron
Model	SYSMAC NX-CIF105
Category	Recording Equipment
Language	English