Omron SYSMAC NX-CIF105 User Manual

23
Regulations and Standards
NX-series Communications Interface Units User’s Manual (W540)
Regulations and Standards
• EMC Directives
• Low Voltage Directive
 EMC Directives
OMRON devices that comply with EU Directives also conform to the related EMC standards so that
they can be more easily built into other devices or the overall machine. The actual products have
been checked for conformity to EMC standards.*1
Whether the products conform to the standards in th
e syste
m used by the customer, however, must
be checked by the customer. EMC-related performance of the OMRON devices that comply with EU
Directives will vary depending on the configuration, wiring, and other conditions of the equipment or
control panel on which the OMRON devices are installed. The customer must, therefore, perform
the final check to confirm that devices and the overall machine conform to EMC standards.
*1. Applicable EMC (Electromagnetic Compatibility) standards are as follows:
EMS (Electromagnetic Susceptibility): EN 6113
1-2
EMI (Electromagnetic Interference): EN 61131-2 (Radiated emission
: 10-m regulations).
 Low Voltage Directive
Always ensure that devices operating at voltages of 50 to 1,000 VAC and 75 to 1,500 VDC meet the
required safety standards. The applicable directive is EN 61010-2-201.
 Conformance to EU Directives
The NX-series Units comply with EU Directives. To ensure that the machine or device in which the
NX-series Units are used complies with EU Directives, the following precautions must be observed.
• The NX-series Units must be installed within
a control panel.
• The SELV requirements must be satisfied for the DC
power supplies that are connected as the
Unit power supplies and I/O power supplies for the NX-series Units.
EMC standard compliance was confirmed for the recommended Power Supplies. Refer to the
us
er’s manual for the connected CPU Unit for the recommended power supplies for the CPU
Rack with an NX-series CPU Unit. Refer to the user’s manual for the connected Communications
Coupler Unit for the recommended power supplies for the Slave Terminal.
• NX-series Units that comply with E
U
Directives also conform to the Common Emission Standard
(EN 61131-2). Radiated Emission characteristics (10-m regulations) may vary depending on the
configuration of the control panel used, other devices connected to the control panel, wiring, and
other conditions.
You must therefore confirm that the overall machine
or equipment in which the NX-series Units
are used complies with EU Directives.
• You must use power supplies with an output hold time of
10 ms or longer for the DC power sup-
plies that are connected as the Unit power supplies and I/O power supplies for the NX-series
Units.
Conformance to EU Directives
Applicable Directives
Concepts

Omron SYSMAC NX-CIF105 Specifications

General

Brand	Omron
Model	SYSMAC NX-CIF105
Category	Recording Equipment
Language	English