En-16
Listening to the Radio
With the built-in tuner, you can enjoy AM and FM radio
stations.
1
Use the tuner’s [INPUT] button, or the
remote controller’s [TUNER] button to
select AM or FM.
In this example, FM has been selected.
(Actual display depends on the country.)
2
Press the [TUNING MODE] button or the
remote controller’s [MODE] button so that
the AUTO indicator appears or disappears
from the display.
Auto Tuning
To activate this mode, press the [TUNING MODE]
button to turn on the “AUTO” indicator. In this
mode, you will receive the broadcast in stereo
sound.
Manual Tuning
To activate this mode, press the [TUNING MODE]
button to turn off the “AUTO” indicator. In this
mode, you will receive the broadcast in monaural
sound.
3
Press the TUNING [] or [] button.
You can also use the remote controller’s arrow
[
]/[] buttons to tune the radio.
Auto Tuning
Searching stops when a station is found.
Manual Tuning
The frequency stops changing when you release
the button.
Press the buttons repeatedly to change the
frequency one step at a time.
The frequency changes in 0.05 MHz steps for FM, and
9
kHz (or 10 kHz) steps for AM.
When tuned to a station, the TUNED indicator appears.
When tuned to a stereo FM station, the FM STEREO
indicator also appears.
Tuning to Weak FM Stereo Stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Listening to AM/FM Stations
,
To Next Page
Loading...
Need help?
General
Weight and Dimensions
