En-18
Listening to the Radio—Continued
■ Name Edit
You can enter a custom name for radio preset for easy
identification. When entered, the custom name will
appear on the display.
The custom name is edited using the character input
screen.
1
Tune to the station of the preset number for
which you want to edit the name, and then
press the [SETUP] button.
2
Use the arrow []/[] button to select
“1.
Hardware Setup,” and then press
[ENTER].
3
Use the arrow []/[] button to select
“Name Edit,” and then press [ENTER].
4
Use the arrow []/[]/[]/[] button to
select a character, and then press [ENTER].
Repeat this step to enter up to 10 characters.
5
When you’ve finished editing the name and
want to store it, be sure to use the arrow
[
]/[]/[]/[] button to select “OK” and
then press [ENTER]. If you fail to do this,
the name won’t be saved.
• Characters are categorized into two groups: character
set 1 primarily for lower case letters, and character set
2 primarily for upper case letters.
You can select characters in each character set by
pressing the [
]/[] buttons.
Press the []/[] buttons to select a character to input,
and then press the [ENTER] button to confirm.
If you do not find a character that you want to select in
the currently-displayed character set, press the [
]/
[
] buttons to display string “Shift BS OK”, use
the [
]/[] buttons to select “Shift”, and then press
the [ENTER] button to display the other character set.
• The following table shows available characters.
The meaning of commands other than alphabetical
characters, numbers and symbols is as follows:
Space:
Enters a space character.
Shift
*1
:
Switches the displayed character.
(Left)/(Right):
Select these to move the cursor within the Name
input area.
BS (Back Space)
*2
:
Deletes the character to the left of the cursor.
OK:
Specifies that the entry is complete.
Tips:
*1 You can also perform this on the remote
controller by using [DIMMER].
*2 Press [D.TUN] button to clear all characters you
entered.
Notes:
• This procedure can also be performed on the tuner by
using [SETUP], TUNING [
]/[
], PRESET [
]/[
],
and [ENTER].
• Press [RETURN] to return to the previous menu.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
