En-33
Advanced Setup—Continued
Note:
When the “Network Control” setting is set to “Disable”,
this setting cannot be selected.
3. Firmware Update
See “Firmware Update” for the update procedure.
Notes:
• The setup menu display will become available several
tens of seconds after the tuner has started up.
• Perform the firmware update only when such an
announcement is posted on the Onkyo web site. Visit
the Onkyo web site for the latest information.
• It takes about 5 to 30 minutes to complete the
firmware update.
(The unit displays the approximate time duration
required for the update.)
Version
Displays the current version of the firmware.
Tuner
via NET:
Performs the firmware update via Internet. Check the
network connection before updating.
via USB:
Performs the firmware update from a USB device.
These settings allow you to update the tuner’s firmware.
Do not shutdown the power of the tuner while updating.
• If you’ve made a change to any item, the display
will indicate “Save [Enter]: Select” when you exit
Network Setup. If you want to apply the changes
you made, press [ENTER].
• If you want to re-do the setup, use [] button to
select “Cancel [Enter]: Select” and then press the
[ENTER] button.
You can also perform the same operation by
pressing the [RETURN] button.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
