Onkyo TX-RZ50 User Manual

166
Setup
6. The guidance about outputting the test tone is displayed. Refer to the
illustration to set up the speaker setup microphone in the listening position.
Follow the on-screen instructions to measure.
• Measurement may not be possible if the test tone is to loud or too soft. Tap
"Level Adjust" to adjust the volume of the test tone.
7. When measurement is complete, "Calculating results" is displayed on the
screen. Tap "Transfer to your product" to transfer the measurement data to
the unit.
8. Disconnect the speaker setup microphone.
• When Dirac Live is used for measurement, the measurement results are also
reected in "2. Speaker" - "Distance" ( →p134) in the Setup menu, and you
will no longer be able to change the values. (The setting units are displayed
as "msec".)
Using Dirac Live
You can use the equalizer function based on the measurements results of Dirac
Live. From "Room EQ" - "Dirac Live" ( →p93) in "Quick Menu", select from
"Slot1" to "Slot3". Note that the same data is saved in all of the slots, but you are
able to create your own original sound quality in the following "Manual Adjust"
section.
• In the Setup menu, when the number of speaker channels, etc., is changed
in "2. Speaker" - "Conguration" ( →p131), the measurement results are
deleted.
• When using Dirac Live, signals with a sampling frequency of 32 kHz are not
supported.
Manual Adjust
You can adjust the sound quality to your own original one by modifying the
equalizer curves based on the volume level of the speakers automatically
measured with Dirac Live. Modify the equalizer on the Onkyo Controller.
• To adjust the sound quality with "Manual Adjust", it is rst necessary to
measure the speakers of this unit with Dirac Live ( →p161, p165).
• This function cannot be used when speaker measurement is done with
AccuEQ Room Calibration ( →p163).
Modifying the equalizer
1. Start the Onkyo Controller and tap the unit when displayed.
2. Tap " " in the top left of the Onkyo Controller screen to display a list of
menus, then tap "Manual Adjust".
3. Select the slot to modify from "Slot1" to "Slot3", then tap "Next".
• The measurement results from Dirac Live are registered in all of the slots
as the default values.
4. After selecting the speaker to adjust rst, modify the equalizer curve.

Onkyo TX-RZ50 Specifications

General

Impedance	16 Ω
Receiver type	Surround
Frequency range	5 - 100000 Hz
Input sensitivity	200 mV
4Ω speaker support	Yes
Audio output channels	11.2 channels
Signal-to-Noise Ratio (SNR)	106 dB
Total Harmonic Distortion (THD)	0.08 %
Power output per channel (20-20KHz@8 Ohm)	250 W
AM band range	530 - 1710 kHz
FM band range	87.5 - 107.9 MHz
Supported radio bands	AM, FM
Preset stations quantity	40
AC input voltage	120 V
AC input frequency	60 Hz
Power consumption (standby)	0.1 W
Power consumption (typical)	850 W
HDMI in	6
USB ports quantity	1
Digital audio optical in	2
Multichannel audio input type	RCA
Component video (YPbPr/YCbCr) in	3
Connectivity technology	Wired
Speakers connectivity type	Clamp terminals
Wi-Fi	No
AirPlay	-
Display	LCD
Product color	Black
Audio decoders	DTS:X, Dolby Atmos
THX-certified	THX
Cables included	AC

Weight and Dimensions

Depth	201.5 mm
Width	435 mm
Height	398 mm
Weight	14000 g