Orolia EdgeSync User Manual

18 | EdgeSync Manual rev 1 orolia.com
• GNSS
• ToD/1PPS Output
Interface :: PTP Timing Ports
Figure 8 Interface :: PTP Timing Ports
The PTP Timing Ports webpage contains the following displays, selections, entries, and buttons:
PTP Timing Ports
Legend: RO = Read Only, RW = Read/Write, WO = Write Only
Labels
Access
Description
PTP Timing Ports – Port 1
DHCP
RW
Enable / Disable DHCP for dynamic IP assignment
Ipv4 Address
RW
Four dot separated octets (0 – 255) for static IP assignment
Subnet Mask
RW
Four dot separated octets (0 – 255) for static IP assignment
Gateway IP
RW
Four dot separated octets (0 – 255) for static IP assignment
Auto Negotiation
RW
Drop down menu for IEEE 802.3 Ethernet link auto-negotiation. Drop
down menu options:
On
1000 Full Duplex
1000 Half Duplex
100 Full Duplex
100 Half Duplex
10 Full Duplex
10 Half Duplex
NOTE: Synchronous Ethernet is supported only for 1000 Full Duplex
ports
Link State
RO
Link Up / Link Down Status with Mbps Data Rate and Full Duplex I/O
IPv6 Address
RO
(Link local) IPv6 address used when PTP::Port::Network Protocol is
IPv6

Orolia EdgeSync Specifications

General

Brand	Orolia
Model	EdgeSync
Category	Switch
Language	English