8 | EdgeSync Manual rev 1 orolia.com
Oscillator Options
EdgeSync: OCXO oscillator, 4-hour holdover for 1.5 µsec accuracy.
EdgeSync+: HP OCXO oscillator, 8-hour holdover for 1.5 µsec accuracy.
PTP Slave Capacity
The EdgeSync has two variants that can support different unicast slave capacity (32 or 128) slaves at
up to 128 sync / delay packets per second when the Managed Clock Engine (MCE) is operated as a
master clock depending on the product SKU. The variants are configured at the factory and cannot be
field upgraded at present. Section 10 of this User Guide presents the two variants available.
Components Block Diagram
The following block diagram defines the main components of the EdgeSync system along with the
physical connections to each component.
Figure 4 EdgeSync Components Block Diagram
• Managed Clock Engine (MCE) is a full packet network-based synchronization engine supporting
IEEE 1588-2008 Precise Time Protocol. The MCE is where IEEE 1588-2008 PTP packet
communication processing runs, and port / BNC provisioning is applied. GNSS signals and User
Interface Processor (UIP) commands are sent to the MCE.
To Next Page
Loading...
General