orolia.com EdgeSync Manual rev 1 | 73
Management interface
Management port is 10/100BaseT RJ45. The Management port supports DHCP, HTTP Webpages,
XML, SNMP (v2,v3), and SSH remote login.
Frequency Out port
BNC 50 ohm. 3.3V LVTTL DC blocked. Frequency Out selectable on the PTP :: Config Webpage.
1PPS timing output
BNC High Impedance 3.3V LVTTL output.
Time-of-Day / 1PPS input/output
ToD / 1PPS port is RJ45, input/output. The pin-outs for this RJ45 connector are defined in ITU-T
G.703 Transmission Systems and Media, Digital Systems and Networks, Section 19. For more
information about ITU-T G.703, see [2].
The Time-of-Day Input format is selectable on the Interface :: GNSS
Webpage and the Time-of-Day
Output format is selectable on the Interface :: ToD/1PPS Output
Webpage. The selections for both
input and output are NMEA, ASCII text and China Mobile.
PTP interface, Port 1 and Port 2
Two Electrical RJ45 ports and two SFP ports. Each RJ45 port can support triple-speed (10/100/1000
Mbps) and each SFP port can support 1GE.
For Port 1, the same PTP messages/packets will be present in both the RJ45 and SFP connections, but
the data rates may be different depending on the speed of the network to which they are connected.
For Port 2, the same PTP messages/packets will be present in both the RJ45 and SFP connections, but
the data rates may be different depending on the speed of the network to which they are connected.
SFP (and SFP+) optical modules for PTP Port 1 and 2
SFP optical modules can be plugged into the PTP ports for Ethernet connectivity instead of the
electrical RJ45 ports. These ports have been designed for standard SFP 1GE modules and dual-rate
SFP+ modules operating at 1GE speed.
Orolia has verified the operation with modules from leading vendors as shown below:
Finisar: FTRJ8519P1BNL, FCLF-8521-3, FTLF1318P3BTL (available from Orolia as SFP-FIBER-SM)
Intel: AFBR709DMZ-IN3
Avago: AFBR-709SMZ, AFBR-5710LZ (available from Orolia as SFP-FIBER-MM)
Ubiquity: UF-MM-1G
To Next Page
Loading...
General