60 | EdgeSync Manual rev 1 orolia.com
In the PTP::Clock page, additional configuration parameters are provided that are specific to G.8275.1
profile as shown below.
Figure 32 G.8275.1 profile - additional configuration parameters
G.8275.2 Telecom Profile
This is another Telecom profile specified for legacy (brownfield) networks that work in conjunction
with the older networks which can comprise switches and routers. This profile is used where there are
network elements which are not PTP-aware and do not participate in PTP protocol processing. They
act as pass-through elements but introduce additional delays which the end-points or slaves need to
compensate for, to maintain timing precision. Since the sync path traverses over routers, this profile
specifies PTP over UDP/IPv4 or UDP/IPv6 and unicast mode of operation.
The figure below shows the details of G.8275.2 telecom profile.
Figure 33 G.8275.2 PTP Profile
In PTP::Clock page, additional configuration parameters are provided that are specific to G.8275.2
profile as shown below.
To Next Page
Loading...
General