II
Safety Precautions
Disconnect the power supply
The product should be placed close to or easily accessible to power sockets, so as to allow easy
disconnection of power supply!
Laser Safety
The laser radiation is harmful to the human body. Since laser components are completely sealed in
the printer, laser radiation will not leak. To avoid laser radiation, please do not randomly
disassemble the printer!
The printer follows the provisions of Class 1 laser products under CFR standard. The printer has a
Class III b laser diode, which has no laser radiation leakage among laser components. The laser
components shall complies with the requirements of: U.S. Code of Federal Regulations, 21 CFR
1040, IEC 60825-1.
Safety Warning
Please note the following safety warnings before using the printer:
There is high-voltage electrode inside the printer. Before cleaning the
printer, make sure the power is turned off!
The fuser unit is hot when and after printing. Touching the fuser unit (the
shaded area as shown) may cause burns!
The fuser unit is attached with a high temperature warning label. Please
do not remove or damage this label.
To Next Page
Loading...
Need help?
General