Replacement
Change oil and replace filter as indicated in the
scheduled maintenance table. Empty the engine
by draining the oil through drainage plug «B».
To facilitate oil drainage, loosen the cap/dipstick
«A».
Once all the oil has drained through the drainage
hole, unscrew the oil cartridge filter and remove it.
Make sure the pre-filter and drainage plug O-rings
are in good conditions.
Lubricate them and refit the mesh filter and the oil
drainage plug, screwing them up to the prescribed
torque.
Refit the new cartridge filter being careful to lubri-
cate the O-ring before fitting it.
Change the engine oil.
Since a certain quantity of oil still remains in the
circuit, engine oil must be added through plug
«A». Then start up the vehicle, leave it running for
a few minutes and switch it off: After about five mi-
nutes, check the level and, if necessary, top-up but
never exceeding the MAX level reference mark.
The cartridge filter must be replaced every time the
oil is changed. Use new oil of the recommended
type for topping up and changing purposes.
N.B.
MP3 500 i.e. SPORT Business_LT_ ABS-ASR_EU_USA (2015)
Maintenance
MAIN - 43
To Next Page
Loading...
Need help?
General