THE ENGINE MUST BE HOT WHEN THE OIL IS CHANGED.
Recommended products
eni i-Ride PG 5W-40 Synthetic based lubricant
for high-performance four-stroke engines.
JASO MA, MA2 - API SL - ACEA A3
Locking torques (N*m)
Engine oil filter 12 - 16 Engine oil drainage plug
24 to 30
Check
This operation must be carried out with the engine
cold and following the procedure below:
- Place the vehicle on its centre stand and on flat
ground.
- Unscrew the cap/dipstick «A», dry it with a clean
cloth and reinsert it, screwing it all the way
down.
- Remove the cap/dipstick again and check that
the level is between the min and max reference
marks; top-up, if required.
If the check is carried out after the vehicle has
been used, and therefore with a hot engine, the
level will be lower; in order to carry out a correct
check, wait at least 10 minutes after the engine
has been stopped so as to get the correct level.
Engine oil top-up
The oil should be topped up after having checked
the level and in any case by adding oil without
ever exceeding the MAX. level.
Restoring the level from the MIN to the MAX marks
requires approx. 400 m³ of oil.
Engine oil filter
Change oil and replace filter as indicated in the scheduled maintenance table. Use new oil of the rec-
ommended type for topping up and changing purposes.
Maintenance MP3 500 i.e. SPORT Business_LT_ ABS-ASR_EU_USA
(2015)
MAIN - 44
To Next Page
Loading...
Need help?
General