Cooling system
Check coolant level when the engine is cold as in-
dicated in the scheduled maintenance table, fol-
lowing the steps below:
Place the vehicle on its centre stand and on flat
ground.
- Unscrew the screw shown in the figure and re-
move the expansion tank cover.
- Top up if the coolant level by undoing the plug
«A», if the coolant level is near or below the level
edge MIN. The coolant level should always be be-
tween the MIN and MAX levels.
-The coolant consists of an ethylene glycol and
corrosion inhibitor based demineralised water- an-
tifreeze solution mix.
CAUTION
DO NOT EXCEED THE MAX. LEVEL WHEN FILLING SO AS
TO AVOID THE COOLANT ESCAPING FROM THE EXPAN-
SION TANK WHEN THE VEHICLE IS IN USE.
Recommended products
AGIP PERMANENT SPEZIAL Ethylene glycol-
based antifreeze fluid with organic inhibition
additives. Red, ready to use.
ASTM D 3306 - ASTM D 4656 - ASTM D 4985 -
CUNA NC 956-16
Braking system
Maintenance MP3 500 i.e. SPORT Business_LT_ ABS-ASR_EU_USA
(2015)
MAIN - 46
To Next Page
Loading...
